Bearing Heaters

Bearing heaters are used to quickly and evenly increase the temperature of bearings via induction heating, which makes it easier to mount them onto a shaft. Most bearing heaters come in 230V and 110V versions.

 

What are bearing heaters used for?

Bearing heaters form part of the tools suite used when repairing or building power transmissions. They make it possible to install bearings without having to execute force using hand tools, which can cause damage.


You can also use bearing heaters to heat other components, like gears, pulleys, bushings and shrink rings, as long as the heated parts form a closed electrical circuit. 

 

Types of bearing heaters

Induction coil bearing heaters and portable bearing induction heaters are the main types available.

 

Coil bearing heaters distribute heat evenly onto bearings with an interference fit mounting. The attached coil is on the outside of the heater component, resulting in reduced heating periods and efficient energy consumption.

 

Portable induction heaters are lightweight, quiet and do not magnetise components. These heaters are suitable for bearings of up to 4.5kg.


...
Read more Read less

Filters

Viewing 1 - 4 of 4 products
Results per page
Description Price Supply Voltage Maximum Bore Size Minimum Bore Size
RS Stock No. 497-9584
Mfr. Part No.TIH030M 230V
BrandSKF
$4,355.11
Each
units
230V ac 300mm 20mm
RS Stock No. 732-4726
Mfr. Part No.729659 C
BrandSKF
$1,488.21
Each
units
230V ac 100mm -
RS Stock No. 680-8018
Mfr. Part No.TIH030M/110V
BrandSKF
$4,895.86
Each
units
110V ac 300mm 20mm
RS Stock No. 845-9564
Mfr. Part No.TIH100M 230V
BrandSKF
$7,276.79
Each
units
200 → 240V 400mm 20mm
Related Products
Stego high performance cartridge heaters prevent the formation ...
Description:
Stego high performance cartridge heaters prevent the formation of condensation and provide an evenly distributed interior air temperature in enclosures. Heating element: high performance cartridgeOverheat protection: built-in temperature limiterHeater body: die-cast aluminum, glass bead finishConnection: 3-pole ...
Heaters specifically intended for anti-condensation and frost protection ...
Description:
Heaters specifically intended for anti-condensation and frost protection in control and equipment cabinets. All types are supplied with DIN rail mounting hardware. Enclosed heater with 0-60°C thermostatic control and LED status indicatorSelf regulating PCT heating elementsThermal cut-outClass II insulation.
Heaters specifically intended for anti-condensation and frost protection ...
Description:
Heaters specifically intended for anti-condensation and frost protection in control and equipment cabinets. All types are supplied with DIN rail mounting hardware. Snap-fastening onto 35 mm support rails EN 50 022 or direct screw-fastening onto the mounting platePTC technology with ...
The CR/CS series of compact high performance fan ...
Description:
The CR/CS series of compact high performance fan heaters prevent formation of condensation and frost and provides an evenly distributed interior air temperature in enclosures with electric/electronic components. The plastic enclosure provides double insulation and acts as protection against contact. ...