ADAFRUIT GEMMA SEQUIN Wearable Starter Kit 1850

Technical data sheets
Legislation and Compliance
RoHS Certificate of Compliance
Product Details

Adafruit GEMMA Wearable Platform v2 Sequin Kit

The GEMMA Sequin pack has everything you need to light up your clothing. Whether you want an LED Hat, LED Shirt or LED Jumper you can make it with this pack.

The Sequin starter pack is supplied with:

Adafruit GEMMA V2 - Miniature wearable electronic platform (RS 124-5508)
Adafruit LED Sequins - Warm White - Pack of 5
Stainless Thin Conductive Thread - 2 ply - 23 meter/76 feet
2 x 2032 Coin Cell Battery Holder - 6V output with On/Off switch (batteries not included) (RS 866-0672)
Needle set - 3/9 sizes - 20 needles

Adafruit GEMMA Wearable Platform v2

GEMMA is a tiny wearable platform built on a round 1.1 inch (2.8 cm) diameter board. The microcontroller at the heart of GEMMA is the Atmel Attiny85 8-bit MCU and is programmable with an Arduino IDE over USB.

This, the second generation of GEMMA, is physically and code-wise identical to the original but now has a Micro-B USB connector and an On-Off switch. It was designed mainly for wearable applications but its small size and low cost makes it great for a wide range of portable projects.

The Attiny85 processor has 8K of flash and 5 I/O pins, including analogue inputs and PWM outputs. There is a USB bootloader available from Adafruit.com but although you can program GEMMA using the Arduino IDE, it is not fully 100% Arduino compatible.

Adafruit GEMMA Wearable Platform

Specifications
Attribute Value
Classification Starter Kit
Kit Name GEMMA SEQUIN
Technology Wearable
7 In stock for delivery within 5 working day(s)
Price (ex. GST) Each
$ 30.31
(exc. GST)
$ 34.86
(inc. GST)
units
Per unit
1 +
$30.31
Related Products
This MPLAB Starter Kit for Serial Memory Products ...
Description:
This MPLAB Starter Kit for Serial Memory Products allows the user to read, write and verify any Microchip serial memory product including I²C, SPI, Microwire and UNI/O bus protocols. It also includes a built-in utility that tests EEPROM endurance.
The FM0-100L-S6E1B8 MCU Starter Kit enables rapid prototype ...
Description:
The FM0-100L-S6E1B8 MCU Starter Kit enables rapid prototype development, based on the Cypress FM0+ S6E1B-Series, a low-power 32-bit ARM Cortex-M0+ flexible Microcontroller. On-board interfaces include USB host and device, micro-SD Card, accelerometer, stereo codec, potentiometer and an RGB colour LED.The ...
The FM0-64L-S6E1C3 MCU Starter Kit enables rapid prototype ...
Description:
The FM0-64L-S6E1C3 MCU Starter Kit enables rapid prototype development, based on the Cypress FM0+ S6E1C-Series, a low-power 32-bit ARM Cortex-M0+ flexible Microcontroller. On-board interfaces include USB host and device, accelerometer, 132 Mbit serial NOR flash, digital audio with stereo codec, ...
The RX71M Microcontroller Starter Kit is available in ...
Description:
The RX71M Microcontroller Starter Kit is available in two versions differing only in the IDE tool supported: CS+ or Eclipse Embedded (e²studio). The kit contains a Pmod™ compatible LCD module and an E1 Emulator pod for debugging purposes. 240MHz R5F571MLCDFC ...