RS PRO 6VA 2 Output Chassis Mounting Transformer, 24V ac, IEC 61558-2-6

Chassis mounting low voltage mains transformers with a single 230Va.c. 50/60Hz primary winding. The two independent secondary windings may be connected in series or parallel to give a wide range of output voltage and current options.

Double section bobbin construction
Fully shrouded bobbins
Full varnish impregnation
Two hole fixing wrap-over clamps
Solder tag terminations
Optional terminal shrouds
100% electrical and flash tested
Tested in accordance with BS3535 and EN 60 742

Looking for an efficient way to step voltages up or down between 230 V AC and 24 V AC? This RS PRO chassis-mounting transformer allows you to choose from a range of output currents and voltages.


The double-section bobbin transformer's two independent secondary windings are configurable in series or in parallel, giving you several ways to set up your circuits. The two fixing holes make it easy to install the transformer with wrap-over clamps. For improved dielectric strength, the coils are varnish-impregnated, and fully shrouded bobbins protect the unit from electrical interference.


A permanent product specification label is mounted on the outer casing, which makes installation safe and easy. The transformer is fully flash and electrical tested in accordance with BS3535 and EN 60742, so it's able to withstand high voltages. Isolating transformers of this kind are commonly used with laboratory instruments and medical equipment.