Fluke I410 Current Clamp, 400A DC Max, AC/DC Adapter, 400A ac AC Max, Voltage Output

Rugged current clamp adaptor suitable for use with multimeters to give non intrusive measurement of d.c. and a.c. current. Integral 1.2m 4mm shrouded plug lead.

Jaws accept conductor size of 1 x 30mm or 2 x 25mm dia.
d.c. current zero control for nulling out jaw/sensor offset
Superior noise immunity allows measurement in electrically noisy environments, such as adjustable speed drive line-side and load currents
Shielded, heat-resistant silicon rubber cable connects clamp to digital multimeter
Battery check mode
Compatible with meter input impedance ≥1MΩ
Conforms to IEC 1010-1 Cat III 600V

Supplied With: 9V PP3 alkaline battery and operators manual.

Get a grip on electrical flow measurements with this current clamp from FLUKE. Wide jaws with a simple open and close lever make it a cinch to clamp a conductor inside. This means you can safely and conveniently check currents and wiring without disconnecting the circuit. The unit has a versatile Hall-effect type of probe, enabling you to take AC and DC current measurements between 1 and 400A for testing and monitoring industrial or domestic circuits. This current clamp easily plugs into multimeters and volt meter test instruments with its 1.6m cable, letting you access hard-to-reach networks.

• Indicator light so you can see at a glance when it's operational
• 60h battery life for reliability

• Automotive industry
• HVAC equipment
• Electrical engineering

The device has a safety category of CAT III 600V, meaning you can use it on busbars as well as distribution and branch circuits.

Simply adjust the product's dial to get a zero reading while the jaws are empty. This ensures your readings are accurate.