RS PRO Hydraulic Bearing Puller, 75 → 105 mm Capacity, 10.0t Force, 8-Piece

RS Pro hydraulic puller set, designed to pull any bearing, belt pulley, gear, round wheel or other tightened parts and accessories used in machinery industry. The pullers special feature is its main shaft can go with any kind of wheel pulling claw. Hydraulic pullers make the job of removing or dismounting bearings simpler, faster and safer

When choosing the right puller for the job, consider using a 3 leg puller if possible - this will give you better load distribution and is a lot safer in use

Spread of bearing puller? It is determined by the width of the part to be pulled.
Reach of bearing puller? It must be at least equal to or larger than the depth of the part that you need to remove.
Force of bearing puller? If you removing rusted parts or where there is a large area of surface contact, a greater force will be required. Consider choosing a puller which force screw diameter is at least half the size of the shaft on the item that you need to remove. Still not sure which puller to choose? Use the next largest simply because undersized bearing puller will slow down the job and nobody has time for that.

10 ton hydraulic power
Sharp edged 4" bearing splitter
Saves time
Portable

• Motor repair shops
• Service company
• Mining
• Paper mills
• Chemical plants
• Shipping
• Offshore
• Maintenance shops

For safety during bearing dismounting be sure to purchase an SKF TMMX 350 Puller Protection Blanket. RS Stock no: 732-4785

Ideal choice for pulling parts of trucks, off-road construction equipment and machinery.

For safety during bearing dismounting be sure to purchase an SKF TMMX 350 Puller Protection Blanket. RS Stock no: 732-4785